The Zemax Knowledgebase is moving!

On August 1, 2025, our articles will only be available on Ansys Optics. As they become available, use the new URL listed at the top of an article to update your bookmarks.
Note: Ansys Optics is in English only. If a translation is available on an individual article, it will be listed below the article title.
  1. Knowledgebase
  2. System Analysis
  3. Stray Light Analysis

Methods for stray light analysis in OpticStudio - webinar

When designing an optical system end-to-end in OpticStudio, one of the last steps is to perform stray light analysis to eliminate unwanted noise in the system. Whether a design is completed in Sequential or Non-Sequential Modes, stray light is best analyzed in Non-Sequential Mode, as it allows tracing both reflected and transmitted ray paths simultaneously and can model wide-angle surface scattering.

Authored By Nick Herringer

Video

Methods for Stray Light Analysis in OpticStudio - YouTube

KA-01781

Was this article helpful?
2 out of 2 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section